How to use the LDO Toolhead PCB with Clockwork 2?

How to use the LDO Toolhead PCB with Clockwork 2?

The LDO Vororn 2.4 kits previous to Rev. C contained the LDO Toolhead PCB which has been designed for the Clockword 1 extruder. From Rev. C the HartK Stealthburner PCB is included, which is compatible with the Clockwork 2 by default.

There is a mod you can use, to make the LDO Toolhead PCB compatible with Clockwork 2, as described here vy LDO: https://www.ldomotion.com/p/guide/18295873486194241

Clockwork 2 with LDO Toolhead PCB
Required additonal parts are:
  1. 1x Machine Screw, FHCS, M3x6
  2. 1x Machine Screw, SHCS, M3x8
  3. 1x LDO-36STH20-1004AHG(VRN)
  4. 1x Hex Nut, M3
  5. 2x Machine Screw, SHCS, M3x6
  6. 1x Machine Screw, SHCS, M3x20
You will also need to print these parts:
Additional printed parts for LDO Toolhead PCB and Clockwork 2


    • Related Articles

    • Why has the XY-Microswitch PCB only 4 pins?

      The X and Y switches are sharing the same ground potential on the PCB, so the second GND connection from the controller board isn't needed to be wired to the PCB (you can choose if you wire in the X or Y GND). The Vin potential only needs to be wired ...

    • Which version is the Stealthburner or Afterburner Toolhead PCB?

      At the moment we are providing version V4.0 (semi assembled only) of the Afterburner PCB , V3.rabbit Afterburner PCB, and the Stealthburner Toolhead PCB as single PCB version (24V) and two PCB version in 5V and 24V.

    • Optotap PCB 5V/24V (2.4.1)

      Voltages supported: The OptoTap 2.4.1 PCB supports 5V and 24V supply voltages provided by the probe port of a toolhead PCB or the controller board. Toolhead PCB support: For all revisions of the HartK Stealthburner Toolhead PCB (1pc or 2pcs) you can ...

    • Voron Stealthburner PCB (1 pc, version 3 & 4)

      This article describes the wiring of the HartK Stealthburner PCB V3 & V4 (1 piece variant). Differences: The main differences between V3 and V4 of the PCB are: V3 has two 24V probe/filament sensor ports, V4 has one 5V probe/sensor port and one 24V ...

    • Anodized LDO Frames and Colour Variations

      Different batches of anodised aluminium frames can have slightly different colours. so if you buy a 0.2 top hat frame or a Clicky Clack door from LDO the colours may deviate from your existing frame. This is unfortunately unavoidable due to the way ...