Wiring Diagram of Stealthburner PCB to Octopus controller board

Wiring Diagram of Stealthburner PCB to Octopus controller board

This wiring diagram shows the standard wiring of the HartK Stealthburner PCB to the Octopus controller board:

    • Related Articles

    • Why has the XY-Microswitch PCB only 4 pins?

      The X and Y switches are sharing the same ground potential on the PCB, so the second GND connection from the controller board isn't needed to be wired to the PCB (you can choose if you wire in the X or Y GND). The Vin potential only needs to be wired ...

    • Which version is the Stealthburner or Afterburner Toolhead PCB?

      At the moment we are providing version V4.0 (semi assembled only) of the Afterburner PCB , V3.rabbit Afterburner PCB, and the Stealthburner Toolhead PCB as single PCB version (24V) and two PCB version in 5V and 24V.

    • Optotap PCB 5V/24V (2.4.1)

      Voltages supported: The OptoTap 2.4.1 PCB supports 5V and 24V supply voltages provided by the probe port of a toolhead PCB or the controller board. Toolhead PCB support: For all revisions of the HartK Stealthburner Toolhead PCB (1pc or 2pcs) you can ...

    • Should I connect a CAN toolhead board directly to my controller board or via USB-to-CAN adaptor module?

      If your controller board (e.g. the Bigtreetech Octopus) supports on board CAN you may wonder if it makes sense to connect a CAN toolhead board directly to it without using a USB to CAN adaptor board. While this is technically possible (Klipper now ...

    • Voron Stealthburner PCB (1 pc, version 3 & 4)

      This article describes the wiring of the HartK Stealthburner PCB V3 & V4 (1 piece variant). Differences: The main differences between V3 and V4 of the PCB are: V3 has two 24V probe/filament sensor ports, V4 has one 5V probe/sensor port and one 24V ...